![]() ![]() # _attribute_listener('gopro_status', _callback) # gopro manager callbacks (defined in gopro manager) If you want to switch back to standard functionality with a Hero4 connected through the 3DR Gimbal, then set the constant: Note: by default, gopromanager tries to connect through the Arduino. SSH into Solo, go to the /usr/bin directory and upload the gopromanager.py and goproconstants.py files Important Note: backup all Solo gopromanager and shotmanager files before uploading the new code so that you can revert back in case something goes south. Note: This mod is compatible with stock firmware and OpenSolo, green cube and the stock black cube. You can enter the ssid and password credentials for up to 3 different Gopros. Load the sketch into the Arduino workbench and change the Wifi settings according to your GoPro in the arduino_secrets.h file. Both libraries can be selected and downloaded in the Arduino workbench library manager tool. In particular, the wifi101 lib and the ArduinoJSON lib. Install the Arduino Sketch on the MKR 1000Įnsure that you have installed the required Arduino MKR1000 libraries in the Arduino workbench. Newer versions than 2.1 do not properly install on Solo. You must have PyMata version 2.1 installed on Solo. Solid green and flashing red LED: indicates data transfer from Solo to GoProĢ.2.Solid green and no red LED: connection to Gopro established.Solid red and solid green LED: connected to Gopro, trying to wake it up if in sleep mode.Solid red and no green LED: Initialized but no Gopro in range.Blinking red and green LED: wifi card error.Red and green LED off,green on board LED on: board is powered, waiting for Solo to finalize GoproManager initialization.Make sure to set the USB Host mode by connecting the 3DRIO pin to Ground on the breakout board. Use a 50 Ohm resistor to avoid overload.Ĭonnect the Arduino MKR1000 USB to the IMX USB port. Solder the red LED to the A1 pin and the green LED to the A3 pin of the MKR1000. A red and a green LEDs to display the wifi status.A Solo breakoutboard with an USB connector (not mandatory, but will save you a lot of time to break out the USB port yourself).You can find a micro to micro USB cable on Amazon or eBay A Micro USB cable to connect the MKR1000 to the IMX6 of Solo. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |